Valentines Day was approaching and Sarah and I have been asked to teach a wreath making class at the public library in April, so we decided to have a "practice class". I created step by step photo directions and we invited some friends to come over and make a wreath.
Sarah and I use a baggie system when we prep our wreaths.
Supplies needed are:
14 inch wire wreath form
Deco Mesh you will need 180 - 6” squares for the 14” wreath
Ribbons
60 - 6 inch pipe cleaners
First we cut the deco mesh into 6 inch squares.
If using three sizes of ribbon, like pictured, cut the widest ribbon 9" long, the medium ribbon 8" long, and the thinnest ribbon 7" long. Trim the ends of the ribbon. I make a V cut on the widest ribbon and angle cut on the other ribbons.
Decide which ribbons and colors of mesh you will be using together for your bundles. For each bundle you will need three squares of mesh. I usually have ribbons for about half of my sets. Since my wreath has 6 sections, I create six of each set. I bag up my sets until I am ready to start work on my wreath. I make ten sets of bundles for a total of 60 bundles.
Once I had everything cut out, I figured out which bundles would have ribbons and which would be just deco mesh.
Abby helped me with the arranging.
I clip my ribbons together and then put the ribbons and deco mesh for this set together. One set down nine more to go.
Roll deco mesh squares into tubes. Twist a pipe cleaner around the mesh. You only need to twist a couple of times. You will be using the ends of the pipe cleaners to attach your bundles to your wreath frame.
If adding ribbon to your bundle, layer ribbons, and place on the bundle before you twist the pipe cleaner.
This bundle has ribbons.
Make one bundle of each set and then figure out what order you want them on your wreath. Make all the bundles and then you are ready to start assembling on the wreath form. You will have 60 bundles I keep the bundles in the ziplock bags. This way if I have to stop and finish another day, everything is altogether.
Attach each bundle with your pipe cleaner on the two middle wires of your wreath frame.
There will be 10 bundles in each section.
We had a fun day making wreaths.
Claire made a beautiful wreath for her front door.
Her wreath is bigger than the ones we've done, so it required more bundles.
Doesn't it look fabulous on her front door?
Joey made a heart shaped wreath.
Here is Joey's finished wreath.
Carolee just getting started.
Carolee's finished wreath.
Sarah's wreath with all the bundles.
Sarah's embellished wreath.
Sarah also made a heart shaped wreath.
My finished Valentines Day wreath.
I used my wreath as part of our door decoration at school. The kids loved my wreath too.
We had so much fun making these wreaths. I've ordered materials for St. Patrick's Day wreaths and Easter/Spring wreaths.
























0 comments:
Post a Comment